![]() The surrounding facets are less sharp, and near the edges of the frame the quality of the image is significantly degraded. ![]() If you look at the kaleidoscopic images #1 through #5, you will see that there is a center triangular facet that looks very sharp. If you have a wider angle lens, that’s great. I would recommend using at least a 24mm lens (on a full frame sensor camera), or an 18mm lens on a camera with a smaller sensor. The number of facets in the resulting photos increases as the width of your lens increases. ![]() To take a picture, I simply put the lens of the camera inside the triangle of mirrors, as you see in (figure A). I used duct tape to hold the unit together, and voila!, a kaleidoscope was born. To construct the kaleidoscope, I simply stood the mirrors on their ends and arranged them in a triangle such that the mirrored surface was inside. I had them smooth the edges of the glass so it wasn’t so sharp (this is important because cut glass is razor sharp), and now it was much safer to handle. I went to a glass shop and asked them to cut three pieces of mirror measuring 6x12”. To take pictures, it’s necessary to add a third mirror to form a triangle. The cost is around $5-$10, and it can be put together in just a few minutes.Ĭommercially manufactured kaleidoscopes have two mirrors inside of them set as a “V”. Several years ago I figured out how to construct a kaleidoscope that would permit photography, and I’ve always had a lot of fun with it. I have long been intrigued with kaleidoscopic images, but it’s virtually impossible to photograph into a traditional kaleidoscope because the hole through which you look to see the beautiful designs is too small.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |